Here's an instruction of riding the Airwheel X3. Normally, the Airwheel X3 is already charged so that you can use it instantly. Just put the Airwheel X3 vertically on the ground and turn on power.

Power and battery level LED will illuminate. When you hear the buzzer beeps, the vehicle is ready to use. If the Airwheel X3 tilts either forward or backwards after power is switched on, then wait until it reverts to upright position before riding.

A four-bar LED indicator is used to indicate battery level. All four will light up when power level is more than 85% and will go off one by one as the level decreases. Please check power level before usage to ensure there is enough power for the return trip. You may want to charge it every time after use. When power level is lower than 10%, all four lights will flicker and the buzzer will sound off. The front part of the treadle will lower itself to force you to decelerate and eventually stop. Please do not restart when this occurs to avoid any accidents.

Sustained range will decrease during winter. This is because the battery performance decreases quickly in cold conditions. In -15°C, for example, battery performance is only about half in comparison to that in room temperature. To prevent injuries caused by speed, the Airwheel X3 comes with a speed control design. When speed exceeds 10km/h, the front part of the treadle will rise slowly; when the speed exceeds 16km/h, the treadle will rise to a 10° angle, to prevent you from inclining forward to further accelerate. As the speed decreases, the angle of the treadle will also lower itself. So when the speed is about to reach its limit, please do not incline forward anymore to force acceleration to prevent injuries.

When Airwheel X3 tilts sideways more than a 45° angle, for example when Airwheel X3 falls, the control system will activate side-tilt protection. The machine will stop running immediately to prevent injuries. The buzzer will sound off a long buzz and the LED will flicker when this is activated. To deactivate this, turn the power off, then restart. Plug in the power source after inserting the charger plug, or else the charger will not activate. This can also prevent potential risks, to ensure a safer charge.

The Airwheel X3 provides a high-power charger. During normal conditions, only 45 mins is needed to be fully charged, 30 mins allows 80% charged. The red light on the charger indicates charging, green indicates charging complete. If not in urgent need, please wait until charging complete before unplugging, because after charging, the protection circuit will perform power flow equilibrium. The water resistance level of the Airwheel X3 is IP 56, allowing it to pass through water of no deeper than 10 mm. It can be used in light rain, but do not steep the vehicle in water or take long rides in heavy rain.